This is what I do....

[bjb007]

Note: I do this for fun only with play money for the mental
challenge.  Nothing I put here should be taken as an inducement
to gamble on roulette, horses, women ... especially women.

I use my software.




which give me all the info I need to make an informed
decision.

Just be fore I took this screenshot I put one unit on each
of 13,16,19 and 22.  16 hit two spins later.  My decision
was based on the numbers in the boxes where you now
see 447 and 385 (they were higher before 16 hit, of course)
There were other factors taken into account.

When the black and even alerts flashed red L/H were more
out of balance than shows now and the average of the last
ten hits was low.  Taking these factors into consideration I
decided to put chips on the black low even numbers -
2,4,6,8 and 10.  As you can see two spins later 10 hit.

My play money bank started at 3460, went down to 2438
(was I getting bored?) and went up to 3572 (+112) in
85 spins.

These kinds of bets don't come along very often but there
are a lot of others which produce a trickle for very little
risk.

Oh yes, forgot to mention that I bet on the last 6 unhit
numbers (you can see four still not hit) and that took
three spins.

Only thing I don't like is the "Play for real money"
popup.

You can see the numbers below on the casino screenshot.

[TwoCatSam]

Bj

I am working to learn your software.  When I have learned all I can on my own, may I ask questions?

Everyone else:  We should open a study thread on this software and do some serious work!

I love the trickles with little risk.  

Sam

[bjb007]

TwoCatSam
Please ask questions.

Yes, the trickle is the only way as far as I'm concerned.
Small risk but a chance of reasonable returns.
Iu per spin isn't unusual.

I had a lesson yesterday in what happens when
you bet without suficient information.

I did some mods to the program and started
using it without realizing that the Std. Dev wasn't
working.  So my play money went down.

So Std Dev is vital for bets on dozens and columns.
When the warning comes on it's time to go to
H/L, O/E and R/B until it gets back to normal.

I'm also working on a new prog - like the above
but designed to process lists of spins and produce
a report showing the state of the various factors
through the spins.

This should be useful for discovering what makes
a system fail when it does - and indicate what
controls should be used to avoid the bad runs.

Anyone who'd like a copy of the prog. please PM
me with an email address and it's yours.

[bjb007]

-